The Plan
07-03-2010, 05:22 PM
#52
So I got a few more things. I ordered a Crane Valve spring tool from Vinci on Wed.
On Thur., I picked up a set of Trend pushrods, 7.400", 5/16" .080" wall. Just like NASCAR runs, only smaller.
Then on Fri., I finally broke down & got a Truetrac, along w/. an install kit. I plan on the shop doin the install, but wanted to purchase 1/2 of what I needed, to break up the cash outlay in parts. Don't wanna spend beyond what I can pay off in a month.
I don't wanna go anywhere this Tues., considering I got parts everyday.
Anyway, when that shop does install, other than labor cost, I wanna get an alum. driveshaft. I'm still undecided on gears, but may very well get some 3.73s, instead of 4.10s.
On Thur., I picked up a set of Trend pushrods, 7.400", 5/16" .080" wall. Just like NASCAR runs, only smaller.
Then on Fri., I finally broke down & got a Truetrac, along w/. an install kit. I plan on the shop doin the install, but wanted to purchase 1/2 of what I needed, to break up the cash outlay in parts. Don't wanna spend beyond what I can pay off in a month.
I don't wanna go anywhere this Tues., considering I got parts everyday.
Anyway, when that shop does install, other than labor cost, I wanna get an alum. driveshaft. I'm still undecided on gears, but may very well get some 3.73s, instead of 4.10s.
Last edited by fastnblu; 07-03-2010 at 05:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
