Keith

I am looking for a S10 rearend for my sister's studebaker project. It needs to be a 3.42 ratio and have disc brakes out of a 4x2. Anyone have any idea where to find one of these? I have tried some online junkyard sites and have had no luck so far. It does not have to be a 8.5" ring gear since it is going into a lightweight car, but that would be a plus. The closest junkyard to me is 60 miles away too.

LOW2000

All of the salvage from our insurance company goes to a salvage unit called CoPart, you might be able to score one from them.

Deckhand

iTrader: (1)

i have my factory 3.42 gears with 8.5 " 10 bolt differential, taken out at 16,000 miles for my 4.10s/eaton swap.

Keith

Yeah I kinda need the whole rearend assembly, but thanks.
CoPart is amazing so far. thanks for the tip.

King James

iTrader: (13)

If you look for a rear axle out of a S-10 ZR2 p-up or ZR2 Blazer, they have 3.73 gears, disc brakes, and are the 8.5" 10 bolt.

cstchevy

Can you say ebay, their all over on their. check it out.

LOW2000

Like I said, we send all our salvage to them, and we're the #2 non-standard auto ins co in the country.

Keith

We need a 3:43 rear gear because that is what the computer is calibrated for. The engine going in the stude is out of a 2000 Blazer with the 4L60-E. Should make for a decently quick lightweight little car for her.
My dad has been checking ebay out and there is a guy in florida that has tons of these rearends, but shipping back home to california would be killer, and it would almost make sense then to have a new one made .
I am at school in Prescott Arizona, and have Las Vegas 3 hours north and Phoenix 1.5 hours south. So I was wondering about online junkyards that could allow me to pick one up and bring it home when I am finished with school here in the next couple of weeks.

LOW2000

One of the major CoPart yards is here in SoCal if that helps any. Don't know if they sell to individuals but it certainly wouldnt hurt to ask.

Keith

Cool, I'll give 'em a try, thanks.