Tach Mounted in a Modified Triple Pillar Pod (56k Warning)
#1
Tach Mounted in a Modified Triple Pillar Pod (56k Warning)
A fellow member contacted me to see if I could mount a 2 5/8 tach into a triple pillar pod. The stand hole size for the pillar pod is 2 1/16. So after some cutting and fiberglassing it is done.
Standard pod, you can see the markings where I am going to cut.
Mold made out of poster board and tape.
First coat of fiberglass.
After some sanding
Applied some adhension promoter and several coat of 2-part filler primer and sanding
I applied some wrinkle finish to restore the factory grain.
Finished Product
The member will apply the final color coat.
Standard pod, you can see the markings where I am going to cut.
Mold made out of poster board and tape.
First coat of fiberglass.
After some sanding
Applied some adhension promoter and several coat of 2-part filler primer and sanding
I applied some wrinkle finish to restore the factory grain.
Finished Product
The member will apply the final color coat.