who's had it done?
#22
Teching In
Join Date: Feb 2011
Location: College Station, Tx
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I know i would have picked up more hp but nothing sounds better than a cammed LS motor. I have done 3 cam jobs myself on some of my project vehicles, but for my 40 thousand dollar daily driver I don't trust myself enough haha
#23
TECH Resident
Join Date: Jul 2005
Location: Bakersfield, CA
Posts: 847
Likes: 0
Received 0 Likes
on
0 Posts
But with ARD you are rolling the dice way more so than if you did it yourself.
#25
TECH Enthusiast
Thread Starter
Join Date: Sep 2008
Location: Pearland
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Ya i can take a video for you tomorrow and get it up but it cost me like 4100 for parts and everything. I put down 397rwhp 385 tq and i am 4 wheel drive. I would have broken 400 if it wasn't 102 degrees today in their shop! I haven't had any bad run ins with them so far and they have worked on a few of my cars. But looking at some of those threads above it does make me think twice...
#26
Teching In
Join Date: Feb 2011
Location: College Station, Tx
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I tried taking a video but it didn't turn out good in the dark, but i will try to get one tomorrow during the day. As far as 1/4 mile i was curious too and i ran my G Tech. With one pass on the G Tech it said 13.4 at 102.5, so im sure I could get that down to low 13s when i have a few runs behind it.
#27
TECH Enthusiast
Thread Starter
Join Date: Sep 2008
Location: Pearland
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
I tried taking a video but it didn't turn out good in the dark, but i will try to get one tomorrow during the day. As far as 1/4 mile i was curious too and i ran my G Tech. With one pass on the G Tech it said 13.4 at 102.5, so im sure I could get that down to low 13s when i have a few runs behind it.