Cam Install big problems!!!
#1
12 Second Truck Club
Thread Starter
iTrader: (7)
Join Date: Jun 2006
Location: colorado above 6000 ft.
Posts: 2,093
Likes: 0
Received 0 Likes
on
0 Posts
Cam Install big problems!!!
I bought a new ls6 cam off a member on LS1 tech. Went to install it last night and the bitch won't go in. Brought it back to the shop today and the piece of **** is bent! I layed it on a granite surface plate and measured it with a highth gage, Its off by .025
Now my truck is torn apart and need to buy a new cam from the dealer so I can get the truck back together.
Im so F**kin pist!!!!
Hopefully he can make this right, I already gave him positive trader rating.
Now my truck is torn apart and need to buy a new cam from the dealer so I can get the truck back together.
Im so F**kin pist!!!!
Hopefully he can make this right, I already gave him positive trader rating.
#4
12 Second Truck Club
Thread Starter
iTrader: (7)
Join Date: Jun 2006
Location: colorado above 6000 ft.
Posts: 2,093
Likes: 0
Received 0 Likes
on
0 Posts
I have no idea. It's a new cam he bought a year ago and never installed it. Just talked to him though, hes gonna refund my money back to me. Now its time to call the stealer ship. I just bought 7.425 push rods for it too so i'll probably need to get the same cam unless there is a better one that will work with these push rods??? The problem is I need it today so I can get it back on the road and out of my buddies garage.
#6
TECH Apprentice
iTrader: (1)
Join Date: Dec 2005
Location: Cape Cod, MA
Posts: 366
Likes: 0
Received 0 Likes
on
0 Posts
Thats good your getting your money back, i wonder if the LPE GT2-3 cam will work with those push rods, its very similar to the LS6 cam. You can also use the Z06 valve springs with it.