Who's using the Comp Cams Retro-Fit Rocker Arm Trunion Kit
#11
Launching!
Thread Starter
iTrader: (4)
Join Date: Jun 2011
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
Well i went ahead and got the comp kit, needed to save a few bucks anyway. No problems with the kit, all the parts were correct and they were a breeze to install. My old stock bearing were definitely wore out, they had lots of play in them. The trunions did help quiet down the valvetrain, still a bit noisy but i guess thats just the prc .650 springs and hardened pushrods for ya. After putting them in i finally went wot with the motor cause i was afraid i would break the stock rocker bearings. She sure likes to spin and pulls pretty good north of 4k. Now the clock ticks on the 60E......
Thread
Thread Starter
Forum
Replies
Last Post
maxspeed05V
GM Parts Classifieds
0
07-19-2015 07:08 PM