"Project LS10"
#201
formerly 2000blackcamaross (6-25-2013)
Thread Starter
iTrader: (41)
Join Date: Nov 2006
Location: Drivers seat in Columbia, Mo
Posts: 648
Likes: 0
Received 0 Likes
on
0 Posts
dammit...i was kidding about having my pickup running before yours. grab a space heater and get to work. it's almost done! then you can sit in the cab with the heater on blast and listen to it run....maybe make some race car sounds with your mouth while hugging those make believe corners
Last edited by LSGUNSS; 01-05-2013 at 08:39 AM.
#203
formerly 2000blackcamaross (6-25-2013)
Thread Starter
iTrader: (41)
Join Date: Nov 2006
Location: Drivers seat in Columbia, Mo
Posts: 648
Likes: 0
Received 0 Likes
on
0 Posts
I bought a FAST 92 for the truck even though I already have a LS6 but, bigger is better right? lol I am in the process of running down a TB for it and I'm trying to round up some other parts that is needed to finish her up. It's still too cold to work in the shop so no work has been done on it in quite some time.
Pic of the intake...
Pic of the intake...
#210
formerly 2000blackcamaross (6-25-2013)
Thread Starter
iTrader: (41)
Join Date: Nov 2006
Location: Drivers seat in Columbia, Mo
Posts: 648
Likes: 0
Received 0 Likes
on
0 Posts
I went to swap intakes the other day and ran in to some issues. First off the evap nipple was in a different position so it hit the truck acc bracket, second the 90mm TB I am running doesn't have a vacuum port on it like the stocker so the catch can setup didn't work, third the LS1 steam tubes will not work with the FAST intake, fourth the port in the waterpump that the steam tube hooks to hit the TB cam. I think I have all the issues addressed and the intake is "on". Just a mock up but it is on. lol Here are a few pics of it and some of the stuff I did to get it to fit.