Ghetto van project
#12
12 Second Truck Club
Thread Starter
iTrader: (18)
Join Date: Aug 2008
Location: Cypress, TX
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
few more updates...
stainless fuel tank was fabbed and welded and put in, valves for helper bags were installed( both sides of the frame are boxed and are the air tanks), compressors were mounted, brake lines ran, we started laying out the wiring harness today. The wheel tubs and side compartments have been finished for a while. Dog house cover is roughly finished. i took the EVAP solenoid off today since we arent using it. Milled out a billet plug for it and used the o-ring off the solenoid. turned out pretty good.
stainless fuel tank was fabbed and welded and put in, valves for helper bags were installed( both sides of the frame are boxed and are the air tanks), compressors were mounted, brake lines ran, we started laying out the wiring harness today. The wheel tubs and side compartments have been finished for a while. Dog house cover is roughly finished. i took the EVAP solenoid off today since we arent using it. Milled out a billet plug for it and used the o-ring off the solenoid. turned out pretty good.
#20
12 Second Truck Club
Thread Starter
iTrader: (18)
Join Date: Aug 2008
Location: Cypress, TX
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
well we made it to SEMA this year!!! PPG, Magnaflow, Dynomat,Nuvite Polishing compound,Macs Tie Downs, Painthouse and a few other sponsors helped us get there!! had an absolute blast. We left saturday morning at 415 and drove it home to Houston. Here is an article I found...
2013-SEMA-Cruise-Chevrolet-Kurbmaster-Van-polished-093 Photo #94271 - Hot Rod Magazine Blog
ill get some more pics up soon
2013-SEMA-Cruise-Chevrolet-Kurbmaster-Van-polished-093 Photo #94271 - Hot Rod Magazine Blog
ill get some more pics up soon