Next stage of the build
#61
FormerVendor
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Posts: 1,940
Likes: 0
Received 0 Likes
on
0 Posts
I spent the Day at Magnuson yesterday with The Tuner and the Machinist that runs R&D at Magnuson. The Machinist had to make a custom inlet so we could use the LS2/7 Throttle Body, he did an outstanding job on it. He also had to machine the upper and lower intake for the injectors and his custom fuel rails. Thanks to everyone at Magnuson that dropped everything they were doing to help with the project yesterday. I took everything that was made yesterday over to my polisher this morning and he had it done by 1pm. I was able to assemble everything except the rear fuel cross-over which will get made tomorrow.
#63
FormerVendor
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Posts: 1,940
Likes: 0
Received 0 Likes
on
0 Posts
The plug and servo clear the drive-shaft by almost 1/4" even with the harness connected. With the truck style Inlet-Forward you cannt flip the throttle body over because of the alternator.
#64
FormerVendor
iTrader: (3)
Join Date: May 2002
Location: Reseda, CA
Posts: 1,853
Likes: 0
Received 0 Likes
on
0 Posts
Lookin great Joe! Magnusson did some fantastic work and in short order too! They're some great guys
Looks like it's getting down to crunch time.
Congrats on your progress so far.
Richard
Looks like it's getting down to crunch time.
Congrats on your progress so far.
Richard
#65
FormerVendor
Thread Starter
iTrader: (4)
Join Date: Aug 2005
Posts: 1,940
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, everyone at Magnuson has been a great help with the build! I am just waiting on the pulley's from Innovators West and then I hope to fire it up by Monday.
Last edited by leftcoast32; 11-01-2007 at 08:04 AM.