Project "Blown HD" my 6/8 drop/shortblock/heads/cam/blower/tranny install
#712
TECH Junkie
What size chambers are you planning to run?My CNC ported chambers measure 79ccs,my pistons are .011 out of the hole with a -17cc dish,with a final compression ratio of 8.8to1 and 6.125 Scat h-beam rods.
#713
FormerVendor
iTrader: (3)
Join Date: May 2002
Location: Reseda, CA
Posts: 1,853
Likes: 0
Received 0 Likes
on
0 Posts
Solid job Grippy. It looks likes miles of smiles on tap
Tomorrow will see a major part of the project done. It's a very nice engine build worthy of the big Mag.
See ya bright and early. Get some rest tonight friend. Tomorrow's a busy day.
Richard
Tomorrow will see a major part of the project done. It's a very nice engine build worthy of the big Mag.
See ya bright and early. Get some rest tonight friend. Tomorrow's a busy day.
Richard
#716
Originally Posted by whitt1
What size chambers are you planning to run?My CNC ported chambers measure 79ccs,my pistons are .011 out of the hole with a -17cc dish,with a final compression ratio of 8.8to1 and 6.125 Scat h-beam rods.
#717
Originally Posted by Richard@WCCH
Solid job Grippy. It looks likes miles of smiles on tap
Tomorrow will see a major part of the project done. It's a very nice engine build worthy of the big Mag.
See ya bright and early. Get some rest tonight friend. Tomorrow's a busy day.
Richard
Tomorrow will see a major part of the project done. It's a very nice engine build worthy of the big Mag.
See ya bright and early. Get some rest tonight friend. Tomorrow's a busy day.
Richard
#718
Originally Posted by nice_n_lo_silverado
Will you still be running those shiny chrome pullys. Where did you get them all. If you don't mind me asking.
#719
Originally Posted by Bill Reid
Talk to Rex about quench... I have no doubt you guys will make the best decision on head gasket thickness vs desired static CR. Ask Rex about your cam and see what he says about dynamic CR...
You're on track grippy!!!
Bill
You're on track grippy!!!
Bill
We will be degreeing the cam tomorrow. Ed Curtis has already address excessive cylinder pressure with this new bumpstick, it will handle 10-1 CR and boost no problemo