What is missing? Build thread of my 4-link.
#1
What is missing? Build thread of my 4-link.
Well I started striping everything for my 4 link and frame shorten. I am putting a short bed on my 2500 to make a one of a kind truck as far as I know. Here are some picks of what I did while I was at work today(bonus to get paid and play!)
Waiting on one set of 4 link bars, and my pan hard bar. I have almost everything else including a fuel cell, high flow fuel pump, and also got my valves in today!
On to the picks.
Waiting on one set of 4 link bars, and my pan hard bar. I have almost everything else including a fuel cell, high flow fuel pump, and also got my valves in today!
On to the picks.
#3
Up
Down
This is laying frame. and the rear has 13" of lift. I have side pipes on the way to cover the gap between the rockers and the ground(gap is 3.5" pipes will cover 3 of it). The front is only 2 inches off but the rear behind the tires is still higher than I want. Not sure how I will get the rear body down but i will figure something out
The front is probably going to get reworked a bit so it will go higher and get just as low but I need to the lower bars and my pan hard for the rear before I am going to change the front.
#7
I hate step side beds so I would say no it won't work. Reality is there is no reason it wouldn't work.
Waiting on the pan hard bar and just a tiny bit more fabrication on the 4 link and it is done! Gotta get the fuel cell mounted and figure out what I am doing for the drive shaft. Not sure if I am going to a one piece or leaving the two piece. I will figure that out early this week and get the shaft made up either way.
Waiting on the pan hard bar and just a tiny bit more fabrication on the 4 link and it is done! Gotta get the fuel cell mounted and figure out what I am doing for the drive shaft. Not sure if I am going to a one piece or leaving the two piece. I will figure that out early this week and get the shaft made up either way.