i think with some smaller tires, it wont look as low, because you will have a lot more fender well exposed. i think it would be very very sexy with it 1-2 inches lower with a shorter tire. but, as it sits, it looks very nice. be careful with that exhaust tip when you are backing up. curbs & parking blocks pop up out of nowhere, especially when you go lower. ask me how i know

 

very nice

 

You guys are killing me

Thanks for the comments and I may leave it like this for a while now

 

that deffinatly looks sweet man!

You used just leafs in the rear? Did you use spindles and keys or just spindles? Any way you could post up some part #'s?

 

Part number for the spindles is 2508 from Belltech and the leafs is 5952 also from belltech. Spindles are rated for 2" and leafs 3".

Yup just leafs in the back. Spindles up front with a little torsion adjusting!

 

looks good!

 

That looks really nice! Good job!

 

looks sweet! hows the 6/8 drop ride??

 

I have the Ventus Rh06 ST's 275/45/20. Love the tire and very cost efficient. Grabs with no problem. Not a lot know about this tire, but I know there are more than a few on PT that have them. I switched from GY GT II's.

And you mentioned you p/u the Aeroforce gauge. I know you'll use it a lot. I like having the engine and trans temp in one pod.

Lisa

 

way to bump a 3.5 year old thread...****** newb