Where to get white gauge faces?
#21
Banned
Thread Starter
iTrader: (2)
Join Date: Apr 2010
Location: Southeast Texas
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
Those white faced stick on gauges are junk. Ended up getting pissed and ripping the factory gauge face in half. 25 bucks down the drain.
I'm not looking for anymore white faced gauges right now. I am in the process of building a 350 and an LS1 350 and I'm not spending anymore money on somebodys overpriced gauges on Ebay.
I'm not looking for anymore white faced gauges right now. I am in the process of building a 350 and an LS1 350 and I'm not spending anymore money on somebodys overpriced gauges on Ebay.
#23
11 sec. Truck Mod
iTrader: (12)
Those white faced stick on gauges are junk. Ended up getting pissed and ripping the factory gauge face in half. 25 bucks down the drain.
I'm not looking for anymore white faced gauges right now. I am in the process of building a 350 and an LS1 350 and I'm not spending anymore money on somebodys overpriced gauges on Ebay.
I'm not looking for anymore white faced gauges right now. I am in the process of building a 350 and an LS1 350 and I'm not spending anymore money on somebodys overpriced gauges on Ebay.
I will post a pic today.
#24
Banned
Thread Starter
iTrader: (2)
Join Date: Apr 2010
Location: Southeast Texas
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
Yep used soapy water but tried to do it while my factory gauge face was still out of the cluster cause my flames were still in the cluster. Figued I'd swap em afterwards. Well the water soaked the paper backing on the back of the gaugeface and ruined it to where it wouldnt peel off, therefore the face was not going to stick to the cluster. Ripped it all in half and walked away. Next time I'll just spend the money and get the real ****
#25
TECH Fanatic
Join Date: Mar 2009
Location: St. Louis Area
Posts: 1,513
Likes: 0
Received 0 Likes
on
0 Posts
Yep used soapy water but tried to do it while my factory gauge face was still out of the cluster cause my flames were still in the cluster. Figued I'd swap em afterwards. Well the water soaked the paper backing on the back of the gaugeface and ruined it to where it wouldnt peel off, therefore the face was not going to stick to the cluster. Ripped it all in half and walked away. Next time I'll just spend the money and get the real ****
#27
Launching!
iTrader: (5)
Join Date: Jul 2009
Location: Temple, Tx
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
Looks good man... Did you take off the needles for the install??
I was looking at these
http://cgi.ebay.com/ebaymotors/99-00...Q5fAccessories