tylertxss

iTrader: (2)

Its going down Jan 7th @ noon. I have my cam/pushrods/valve springs/timing chain/injectors/UDP/160 thermo that I am wanting to install while I'm home. Anyone wanna come over and make it a G2G? We can BBQ and make a day of it. Let me know!

TSP 228 Cam
160 Thermo
25% Underdrive Pulley
IWIS Chain
Hardened Pushrods
1218 Beehive Valvesprings
LS7 42lb injectors

Chevy-Fun

iTrader: (1)

I'd like to go an watch an learn. I'll bring the beer. Never messed with any ls engine, just 350. An hoping to have my setup by march in time for the black bear tune in ftw.

zachm89

iTrader: (16)

At this point, I don't think my truck will be back together by then :/ I'll figure out a way to make it up there with the tranny though.

TXSZ66AVLANCHE

iTrader: (7)

Why the 160 thermostat?

gs7793

iTrader: (8)

I'll see what I have going that day...If I'm free I might come by and bring some help and some tools...we'll see what's going on

454navyss

iTrader: (46)

if im free, ill join yall

gs7793

iTrader: (8)

We're gonna need to start earlier than noon though if you want it done that day in case we run into problems...especially if we're gonna BBQ and bs around lol

Sn0wBa11

iTrader: (2)

Too bad I'm not in ft worth anymore this would be fun. If you don't run into any problems you should be able to do a cam/spring swap in just a few hours

tylertxss

iTrader: (2)

I kind of figured why not do while im wrenching, 160 degrees seems a little better than 195...why do u guys say no the the 160 thermo? We can start earlier, I just figured no1 would want to get up too early, im game for whatever time everyone thinks is good! Im ready to get started for sure.

tylertxss

iTrader: (2)

Thats a long way to peddle man! I hope you can make it!