Caged, backhalfed, 02 xcab silverado...
#2
Baltimore Whore
iTrader: (95)
Joined: Apr 2004
Posts: 16,820
Likes: 0
Received 2 Likes
on
2 Posts
From: In a van DOWN BY THE RIVER
I dunno if they are lurkers here or not My ? is why would they cut the section of the bed after the wheel well? To make it a even shorter short bed? Beautiful work none the less.. I hope this thing is sitting on the ground when finished, goes singles.. IMO if you have to put steam rollers on it like that, if it doesn't go singles then it was not worth it.. By the looks of it, it should be getting serious power, because that is a pretty serious tube back half, cage..
#5
Custm2500's Rude Friend
iTrader: (17)
To bad they used mild steel...
The reason for the cut was because it was a long bed and they shortened it
Look for the middle stake hole. Only long beds had that.
02_silverado_057
The reason for the cut was because it was a long bed and they shortened it
Look for the middle stake hole. Only long beds had that.
02_silverado_057
#7
Baltimore Whore
iTrader: (95)
Joined: Apr 2004
Posts: 16,820
Likes: 0
Received 2 Likes
on
2 Posts
From: In a van DOWN BY THE RIVER
To bad they used mild steel...
The reason for the cut was because it was a long bed and they shortened it
Look for the middle stake hole. Only long beds had that.
02_silverado_057
The reason for the cut was because it was a long bed and they shortened it
Look for the middle stake hole. Only long beds had that.
02_silverado_057
Agreed//