Converter wont stay locked
#18
12 Second Truck Club
iTrader: (13)
i think i've talked to you about my truck before. we turned up the pressure in the force motor table and it helped, but when we changed it, it was cold outside. now its warming up here in tx and its unlocking/locking again??? i hate to just keep throwing pressure at it. but maybe its not bad since its mainly in the low torque area??
#19
Former Vendor
iTrader: (11)
Join Date: Feb 2006
Location: California
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
I have the exact opposite problem as you guys. After the high stall(2600-2800) converter went in it locks and does not unlock quickly enough causing bucking. If I am cruising at 50 MPH on a main street and I take my foot off to coast to a stop sign or light it will start bucking below 45. I want it to unlock sooner so it will not buck plus it comes back up to speed faster with the tc unlocked to pass. If it stays locked and I give it a little gas it does nothing so I have to practically mash the go pedal so it downshifts and unlocks the tc. With the tc unlocked it has higher rpm so it accelerates faster. At 50 in 4th I am at 1400 rpm so it is out of the power band but with the tc unlocked it shoots to 3K and pulls the truck really good.
#20
TECH Resident
Thread Starter
I lowered the first two rows by 1.5% and the 3rd by .5%, did not change anything.
I guess I'm confused about when logging, how I would go about linking delivered trans torque to relate to the Force Motor Current table.
I guess I'm confused about when logging, how I would go about linking delivered trans torque to relate to the Force Motor Current table.