Crank relearn now have noise
#22
formerly Stroked-DSM (11/24/2010)
Thread Starter
iTrader: (3)
Join Date: May 2009
Location: Florida
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
Almost catastrophic. The thrust bearing went bad, which I think may have been builders error. I noticed the crank pulley moving slightly after it threw a belt around 1000 miles after it was built, but thought it was just the balancer. The motor ran fine, wasn't down on power or oil pressure, developed a slight knock right before I yanked it out.
This motor is entirely new; covers, oil pump, intake, etc etc. I replaced the converter as well.
This motor is entirely new; covers, oil pump, intake, etc etc. I replaced the converter as well.
#24
formerly Stroked-DSM (11/24/2010)
Thread Starter
iTrader: (3)
Join Date: May 2009
Location: Florida
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
It's not top end related. Tore into the heads a little and everything was fine. Nothing seemed to be contaminating the oil either. Gonna pull the pan next..
Thread
Thread Starter
Forum
Replies
Last Post
lukn4trbl355
INTERNAL ENGINE MODIFICATIONS
7
10-21-2015 11:19 PM