Gen III Flex fuel
#1
TECH Apprentice
Thread Starter
iTrader: (4)
Join Date: Apr 2010
Location: STL
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Gen III Flex fuel
I just wanted to show what i have been working on for a few weeks now. This is a 1999 FLEX FUEL silverado. Using a 0411 pcm and a flex fuel content sensor. Pretty simple of an installation, just wanted to show that it can be done! Wirings still messy but it will get cleaned up, i just wanted to protect it a little better before i get better wire wrap.
Sensor and pigtail
Wired in and going!
Overall it is awesome being able to go to any gas station and put in any mix, as before i was just on 85 so i struggled with the mixtures.
Sensor and pigtail
Wired in and going!
Overall it is awesome being able to go to any gas station and put in any mix, as before i was just on 85 so i struggled with the mixtures.
#2
TECH Fanatic
Does that sensor give you temperature and contamination detection as well?
I would be a little worried about that hose touching the firewall, if the engine moves enough you'll have fuel everywhere.
I would be a little worried about that hose touching the firewall, if the engine moves enough you'll have fuel everywhere.
#4
TECH Senior Member
iTrader: (26)
Can you post some more details on this?? Like what pin the PCM uses for the sensor? I have another one of those sensors as well as the old type of sensor. I'm wanting to do this on my 01 turbo truck but EFILive doesn't have a COS 2 bar for the only flex fuel OS I found for the 99-02 ECM's. Does HPT? I do have HPT, so could convert over. Would really like to convert this truck to FF like I did my Cruze.
Can you post the tune file your using if you don't mind?
Can you post the tune file your using if you don't mind?
#10
TECH Senior Member
iTrader: (26)
But I am still interested in how you wired it up. Hell, I might just do it with a 1 bar scaled MAF tune if I have too.