got a problem??
#1
TECH Resident
Thread Starter
iTrader: (36)
Join Date: Feb 2005
Location: Texarkana, AR
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
got a problem??
when at the track fri. night my truck was throwing a code and showing reduced engine power in the message center. it was shutting the truck down before i could get halfway down the track. and it seemed like it was running on 2 cylinders afterwards. but when i killed it and cranked it back up it would be fine until i tried to make another pass. the code was U0107 lost communication with throttle body acuator switch, or something real close to that. does anyone know the problem with this or has anyone had this same problem. this just started doing it since the headwork and bigger cam. and it seems to do it worse with the cutouts open, and it does it real bad when i pull the passenger headlight out. all help is greatly appreciated.
Last edited by KBOBOZ71; 05-15-2006 at 12:42 PM.
#3
TECH Enthusiast
iTrader: (2)
Join Date: Aug 2005
Location: Cleveland, Ohio
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by KBOBOZ71
when at the track fri. night my truck was throwing a code and showing reduced engine power in the message center. it was shutting the truck down before i could get halfway down the track. and it seemed like it was running on 2 cylinders afterwards. but when i killed it and cranked it back up it would be fine until i tried to make another pass. the code was U0107 lost communication with throttle body acuator switch, or something real close to that. does anyone know the problem with this or has anyone had this same problem. this just started doing it since the headwork and bigger cam. and it seems to do it worse with the cutouts open, and it does it real bad when i pull the passenger headlight out. all help is greatly appreciated.
#6
Launching!
Join Date: Jul 2004
Location: North TX
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jmproductions
Linda had that Reduced Engine Power message but also her truck wouldn't turn over. PCM swap solved it.
Trending Topics
#8
Launching!
Join Date: Jul 2004
Location: North TX
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jmproductions
How do you know???