hard start after flashing tune
#21
TECH Fanatic
Thread Starter
iTrader: (11)
Join Date: Dec 2009
Location: Birmingham, AL
Posts: 1,573
Likes: 0
Received 0 Likes
on
0 Posts
mine was set to 10000rpm...? set it to 0 and no change!! tried changing all the code settings from "no MIL reported" to "mil on first error"... no change! this is getting frustrating!!!!!!
#23
TECH Fanatic
Thread Starter
iTrader: (11)
Join Date: Dec 2009
Location: Birmingham, AL
Posts: 1,573
Likes: 0
Received 0 Likes
on
0 Posts
im out of jokes to make about it!!! haha
yesterday i flashed a tune and it took probably 75 tries to get it going, i was sitting there for a half hour waiting on it!
yesterday i flashed a tune and it took probably 75 tries to get it going, i was sitting there for a half hour waiting on it!
#28
9 Second Club
iTrader: (2)
Join Date: Jul 2002
Location: on the dyno tuning in MD
Posts: 2,585
Likes: 0
Received 0 Likes
on
0 Posts
One thing that might help - unpin the MAF signal wire to run speed density vice doing it in the tune. I had a truck give me a bunch of trouble once trying to fail the MAF in the tune for speed density.
#29
TECH Fanatic
Thread Starter
iTrader: (11)
Join Date: Dec 2009
Location: Birmingham, AL
Posts: 1,573
Likes: 0
Received 0 Likes
on
0 Posts
heres what its doing...
WON'T START!!! - YouTube
any wires related to the MAF are completely out of the harness, if that's what youre saying
WON'T START!!! - YouTube
any wires related to the MAF are completely out of the harness, if that's what youre saying